Đồng hồ áp suất Màng Sandwich mặt 100, 0 – 6 kg/cm²(g)

FEATURES Compliance to latest EN – 837 Standard Range: (-) to 1600 kg / cm2 Bourdon in SS316 Ti as standard, providing better Mechanical properties guaranteeing repeatability & accuracy Accuracy ± 1% (Standard ) ± 0.5% FSD on request Unit of measurement – kg / cm2, bar, PSI, kPa, MPa Pressure Gauges intended for process […]

Liên hệ:

0975 09 12 12

Giá bán: Liên hệ ( Chưa VAT )

Thông tin sản phẩm
Video

FEATURES

Compliance to latest EN – 837 Standard
Range: (-) to 1600 kg / cm2
Bourdon in SS316 Ti as standard, providing better Mechanical properties guaranteeing repeatability & accuracy
Accuracy ± 1% (Standard ) ± 0.5% FSD on request
Unit of measurement – kg / cm2, bar, PSI, kPa, MPa
Pressure Gauges intended for process industries such as chemicals, petro- chemicals, energy or gas industry, food processing, nuclear, etc
These pressure gauges have been designed to satisfy requirement to operate in aggressive environment

SPECIFICATIONS
Ref.standard	EN – 837
Dial	100 mm/150mm in Aluminium whitebackground Black marking
Cse	SS304/SS316 with bayonet bezel phenol with Screwed bezel.
Pritection	IP-68 (IS:13947Part I/IEC:60529)
Window	Safety glass (shatter proof/To ughened glass
Bourdon	SS316,SS316Ti,SS316L, Monel
Socket	22mm Square in SS316,SS316Ti,SS316L, Monel
Movment	SS304,SS316.
Range	As per EN 837(refer table)minimum span 0.6kg/CM2 Maximum 1600kg/CM2
Connection	½ *NPT (M) as standard (other optional)
Accuracy	± 1 % FSD (0.5% on request)
Over range	As per EN 837
Suitability	(-) 20°c to 80°c (Service Temperature)
Zero adjustment	Micrometer pointer
Blow out disc	provided (on top)
Optional	IBR Certification Maximum pointer NACE compliance External Kn0b for zero setting Built in snubber Built in Gauge saver Liquied Filled case ( SS case only ) Vacuum protection

SANDWICH TYPE DIAPHRAGM SEAL

Sandwich type Diaphragm Seals are the most commonly used Diaphragm Seals. The Diaphragm is sandwiched between Top Chamber & Bottom Chamber / Flange. These are available threaded as well as flanged process connection. For low Pressure Range & Smaller Flange Sizes, section type Diaphragm Seals are used.

Optionally, Flushing connection of 1⁄4 NPT(F) or 1⁄2 NPT(F) can be provided which enables the user to flush out / clean the area below the diaphragm without removing the Seal from the process line. For threaded process connection and flange connection with section, flushing connection shall be directly provided on the Bottom Chamber. For bigger Flange sizes, separate Flushing Rings (Spacer Rings) are usually provided.